2010 Chev Silverado 2500 basic Key
Encore E6 Remote starter. with RS232 serial Idatalink
EVO-ALL Harware 6.0 , Firmware 70.[36]
I'll start from the begining. I installed everything acording to fortins Guide #59041. I wired everything up and since this truck doesn't even have power locks so I installed actuators and relays ran off the remote start car alarm(which work fine).
Programed the EVO but was not working at step 4 where you turn the key to IGN. The led would not flash blue. I tried a few times and it would not work. Pulled it out and checked settings with the Flashlink and everything looked OK. Went back out and tried again, this time it worked. Back to the Flashlink to dcryptor which seemed to work. Back to truck to give it a try and no remote start. No lights at all on the EVO even when pressing the remote start button or door lock buttons. The truck will still start with the key. I tried the F1 and F2 protocals for the datalink but it's the same. The Encore says it won't try to remote start without neutral safety grounded, hood pin not grounded, brake pedel no 12v. All these i believe should come from the EVO-ALL. I don't think it is communicating. Any Ideas?